Conduit
Offsets, stub-ups and saddles for electricians bending conduit.
For iPhone · In development, not on the App Store yet
A fast, offline iPhone calculator for bending conduit, in inches and fractions. Results update as you type, every bend comes with a dimensioned diagram, and the working shows exactly how each mark was found.
Screenshots

Every bend, one tap away 
Offsets with marks and shrink 
90° stub-ups from the deduct 
3-point saddles over an obstacle 
Save bends and come back to them 
Bender data by conduit size 
Tape maths in feet and inches
Screenshots from the current prototype. Reference values shown in the app are sample data.
What it does
Offsets, including rolling offsets
Spacing, shrink and marks, by the multiplier method or from your bender’s radius. The working always names the method it used.
90° stub-ups
Where to put the mark for a stub height, using the deduct for your bender and conduit size.
3-point saddles
Centre and outer marks to clear a pipe or other obstacle, with a 45° or 60° centre bend.
Bender data
Radius, deduct, gain and outside diameter for each conduit size, all in one table.
Bend list and fraction calculator
Save bends with a label and reopen them later, and do tape maths in feet, inches and fractions.
Built for the job site
Its own keypad with large keys, so there is no system keyboard in the way. Works with no signal. No account, no ads.